A triple flash on the CLR2060 diagnostic LED reports both of the board's failure conditions together.
Model compatibility: U-Line reuses display codes across control platforms, so 3 flashes may mean something different on another appliance family or generation. Confirm this against your model’s documentation and record your full model number before acting.
Plain language
What this code means
A triple flash reports both of the board's failure conditions together.
Reading the CLR2060 flash counts
Flashes
What the LED is saying
1
Overflow protection circuit open, for units equipped with a P-60 pump
2
Open thermistor, or an out-of-range reading that is too warm
3
Both problems from the rows above
Series and board
The table applies to the CLR2060 built after 12/1/03 with the revised control board. It is an older series.
At a glance
Code
3 flashes
What it means
A triple flash reports both of the board's failure conditions together.
What you can check
Interrupt power to the board to clear the stored code, because the ON/OFF/CLN switch is not a substitute. Write down the flash count first.
When to call a technician
If three flashes appear again afterward, both conditions are still present. Call for a service visit.
Power and the stored code
A stored code leaves only when power to the board is interrupted. The ON/OFF/CLN switch is not a substitute. If three flashes appear again afterward, both conditions are still there.
Where to get ice maker repair near Miami, New York, Houston, Los Angeles or San Diego
The Miami, New York, Houston, Los Angeles and San Diego metro areas are served at (844) 706-1091. Before calling, write down the flash count, the CLR2060 model number and whether power was cut. Browse the ice maker repair page for more.
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Code still showing?
Get this U-Line fault diagnosed properly
A returning error code usually needs model-specific testing. Book a visit for a clear estimate — no surprise add-ons.
Fix it right
Recommended repair service
U-Line Ice Maker Repair
Ice maker not producing ice, making too little, or leaking? We diagnose U-Line ice makers thoroughly.