On the CLR2060 the diagnostic LED flashes two times for an open thermistor or an out-of-range, too warm, condition.
Model compatibility: U-Line reuses display codes across control platforms, so 2 flashes may mean something different on another appliance family or generation. Confirm this against your model’s documentation and record your full model number before acting.
Plain language
What this code means
Two LED flashes mean an open thermistor or an out-of-range, too warm, condition.
2 flashes on the CLR2060 LED
Meaning: the control board detected an open thermistor, or a temperature that is out of range because it is too warm.
Where it shows: the diagnostic LED, which carries the codes on this board.
Series: legacy. It covers CLR2060 units made after 12/1/03 that have the revised control board.
What the LED can report
The flash count separates three situations. One flash is the overflow protection circuit open on P-60 pump units. Two flashes are the thermistor or too-warm problem. Three flashes mean the unit has both.
At a glance
Code
2 flashes
What it means
Two LED flashes mean an open thermistor or an out-of-range, too warm, condition.
What you can check
Cut power to the control board, since that is the only way to clear a stored code. The ON/OFF/CLN switch will not do it.
When to call a technician
A code that comes back after the power interruption points to a fault that is still present, so book a service visit.
Resetting a stored code
Cutting power to the board is the single way to clear a code. The ON/OFF/CLN switch will not do it. A code that comes back after the power interruption points to a fault that is still there, so a technician should look at the machine.
Ice maker repair in the Miami, New York, Houston, Los Angeles and San Diego metro areas
U-Line ice maker service is available across the Miami, New York, Houston, Los Angeles and San Diego metro areas at (844) 706-1091. Mention the two-flash code and the model number, and say whether you cut power to the board. Details of ice maker repair are online.
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Code still showing?
Get this U-Line fault diagnosed properly
A returning error code usually needs model-specific testing. Book a visit for a clear estimate — no surprise add-ons.
Fix it right
Recommended repair service
U-Line Ice Maker Repair
Ice maker not producing ice, making too little, or leaking? We diagnose U-Line ice makers thoroughly.