Skip to content
Response time varies by location and service availability.
Error Code

U-Line Clear Ice Maker 1 Flash Code: Overflow Circuit Open

Error code 1 flash
Appliance Ice Maker
Quick answer

On the older CLR2060 with the diagnostic LED, one flash signals an open overflow protection circuit on P-60 pump units.

Model compatibility: U-Line reuses display codes across control platforms, so 1 flash may mean something different on another appliance family or generation. Confirm this against your model’s documentation and record your full model number before acting.

Plain language

What this code means

The overflow protection circuit is open (only on units with a P-60 pump).

Code at a glance

  • Signal: LED flashes one time
  • Meaning: overflow protection circuit open
  • Condition: only on P-60 pump units
  • Series: CLR2060 manufactured after 12/1/03, legacy

How to reset

  1. Interrupt the power going to the control board.
  2. Do not rely on the ON/OFF/CLN switch; turning it off leaves the code in place.

With a steady light, the board is powered and operation is normal. On this revised board the LED reports errors by its flash count.

At a glance

Code 1 flash
What it means The overflow protection circuit is open (only on units with a P-60 pump).
What you can check Interrupt the power going to the control board, because the ON/OFF/CLN switch does not clear the code. A steady light afterward means the board is powered and working normally.
When to call a technician If the single flash returns after the power interruption, the open overflow protection circuit is still there, so a technician should inspect the machine.

See also

Compare with 2 flashes and 3 flashes on the same LED.

Ice maker repair across the Miami, New York, Houston, Los Angeles and San Diego metro areas

Call (844) 706-1091 from any of the Miami, New York, Houston, Los Angeles and San Diego metro areas. Report the one-flash pattern and the model, and see ice maker repair.

Source: U-Line Service and Parts Manual P/N 30-10010 (Rev. 2/05), control board LED section

Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.

Code still showing?

Get this U-Line fault diagnosed properly

A returning error code usually needs model-specific testing. Book a visit for a clear estimate — no surprise add-ons.

Code still showing?

Get this U-Line fault diagnosed properly

A returning error code usually needs model-specific testing. Book a visit for a clear estimate — no surprise add-ons.

Book a repair

Tell us what’s wrong — we’ll take it from there

Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.

Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area Serving Miami, New York, Houston, Los Angeles and San Diego metro areas.
Response time Response time varies by location and service availability.

Request your repair

Fill in the form below and we’ll confirm an appointment.

Call Book a visit