Skip to content
Response time varies by location and service availability.
Error Code

U-Line Ice Maker Code: 2 Flashes, Thermistor or Too Warm

Error code 2 flashes
Appliance Ice Maker
Quick answer

On the CLR2060 the diagnostic LED flashes two times for an open thermistor or an out-of-range, too warm, condition.

Model compatibility: U-Line reuses display codes across control platforms, so 2 flashes may mean something different on another appliance family or generation. Confirm this against your model’s documentation and record your full model number before acting.

Plain language

What this code means

Two LED flashes mean an open thermistor or an out-of-range, too warm, condition.

2 flashes on the CLR2060 LED

  • Meaning: the control board detected an open thermistor, or a temperature that is out of range because it is too warm.
  • Where it shows: the diagnostic LED, which carries the codes on this board.
  • Series: legacy. It covers CLR2060 units made after 12/1/03 that have the revised control board.

What the LED can report

The flash count separates three situations. One flash is the overflow protection circuit open on P-60 pump units. Two flashes are the thermistor or too-warm problem. Three flashes mean the unit has both.

At a glance

Code 2 flashes
What it means Two LED flashes mean an open thermistor or an out-of-range, too warm, condition.
What you can check Cut power to the control board, since that is the only way to clear a stored code. The ON/OFF/CLN switch will not do it.
When to call a technician A code that comes back after the power interruption points to a fault that is still present, so book a service visit.

Resetting a stored code

Cutting power to the board is the single way to clear a code. The ON/OFF/CLN switch will not do it. A code that comes back after the power interruption points to a fault that is still there, so a technician should look at the machine.

Neighboring codes

Ice maker repair in the Miami, New York, Houston, Los Angeles and San Diego metro areas

U-Line ice maker service is available across the Miami, New York, Houston, Los Angeles and San Diego metro areas at (844) 706-1091. Mention the two-flash code and the model number, and say whether you cut power to the board. Details of ice maker repair are online.

Source: U-Line Service and Parts Manual P/N 30-10010 (Rev. 2/05), control board LED

Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.

Code still showing?

Get this U-Line fault diagnosed properly

A returning error code usually needs model-specific testing. Book a visit for a clear estimate — no surprise add-ons.

Code still showing?

Get this U-Line fault diagnosed properly

A returning error code usually needs model-specific testing. Book a visit for a clear estimate — no surprise add-ons.

Book a repair

Tell us what’s wrong — we’ll take it from there

Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.

Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area Serving Miami, New York, Houston, Los Angeles and San Diego metro areas.
Response time Response time varies by location and service availability.

Request your repair

Fill in the form below and we’ll confirm an appointment.

Call Book a visit