Skip to content
Response time varies by location and service availability.
Error Code

U-Line Ice Maker Rapid Flash Code: High Heat

Error code Rapid flash
Appliance Ice Maker
Quick answer

Rapid flash is a high-heat warning on older U-Line clear ice makers: CLR60, and the original CLR2060 and CLRCO2075 boards.

Model compatibility: U-Line reuses display codes across control platforms, so Rapid flash may mean something different on another appliance family or generation. Confirm this against your model’s documentation and record your full model number before acting.

Plain language

What this code means

Control board LED rapid flashing: high-heat signal from the thermistor (dirty condenser, inadequate airflow, failed condenser fan motor, etc.); the unit stops operating.

Rapid flash in short

Older clear ice makers use one LED on the control board to report their state. When it flashes rapidly, the thermistor is sending a high-heat signal and the machine shuts down. This applies to the CLR60 and to the original boards of the CLR2060 and CLRCO2075, all legacy equipment.

At a glance

Code Rapid flash
What it means Rapid LED flash on the control board is a high-heat signal from the thermistor; the unit stops operating.
What you can check Power the unit down before any work. A dirty condensing coil can be cleaned, and poor airflow around a unit enclosed behind closed doors is another known cause.
When to call a technician A failed condenser fan motor needs replacing and a stalled blade needs freeing, so book a service visit for the fan side of the problem.

The LED’s three behaviours

  1. Steady: the board has power and operation is normal.
  2. Slow flash: a sensor problem.
  3. Rapid flash: high heat.

Where the heat comes from

A dirty condenser, poor airflow around a unit enclosed behind closed doors, and a failed condenser fan motor all appear in the manuals. For a dirty coil the remedy shown is to clean the condensing coil; a stalled fan blade is freed or the motor replaced. Power the unit down before any of that work.

Related signals

Look at Slow flash for the sensor version of the LED, and at Zone T and Amb Thrm for thermistor circuit codes on a 3000-series unit.

Ice maker repair service for older models

Technicians cover the Miami, New York, Houston, Los Angeles and San Diego metro areas. Ring (844) 706-1091 about ice maker repair and tell them it is a rapid flash on an older clear ice maker, along with the model number.

Source: U-Line CLR60 Clear Ice Maker Service and Parts Manual (Thermistor, Check Procedure w/LED Light on Control Board); U-Line Service and Parts Manual P/N 30-10010 (Rev. 2/05), control board LED, New CLR2060 control board design

Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.

Code still showing?

Get this U-Line fault diagnosed properly

A returning error code usually needs model-specific testing. Book a visit for a clear estimate — no surprise add-ons.

Code still showing?

Get this U-Line fault diagnosed properly

A returning error code usually needs model-specific testing. Book a visit for a clear estimate — no surprise add-ons.

Book a repair

Tell us what’s wrong — we’ll take it from there

Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.

Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area Serving Miami, New York, Houston, Los Angeles and San Diego metro areas.
Response time Response time varies by location and service availability.

Request your repair

Fill in the form below and we’ll confirm an appointment.

Call Book a visit